R-1125 Harness Mount Bar
R-1125 Harness Mount Bar


 
Alternative Views:


For Corvette C7
MSRP: $968.93


BK Part Number: R-1125
 

Description Installation Instructions Additional Description
 
The C7 harness mount bar has been tested and certified using all possible mounting points by an independent lab to handle the types of forces required by the National Highway Traffic Safety Admin. DOT and SAE J385 Rev. MAR 95, Motor Vehicle Seat Belt Anchorages-Performance Requirements.

The C7 harness mount bar properly locates and supports racing shoulder harnesses relative to the driver. In the case of an accident, it helps protect the driver's shoulders and spine. The harness guides also prevent excessive shifting and fatigue of the driver during the high G loads of cornering and braking. Our bars are easy to install and remove, use only existing holes and mounting points.

Note: Because of mounting locations in the C7, the b-pillar plastic sail panel covers will require slot on either side to be cut. Sail panels replacements can be ordered from your GM Dealer, part 23432694 for driver side, and part 23432695 for passenger side if you do not want to cut the original panels. Strength requirements for harness mounts are considerably greater than those for harness guide bars since they must support the entire load applied to the belts.

Material: Type 304, stainless steel.
Finish: Powder-coated in durable black wrinkle-finish
Weight: 17.12 lbs.
Models: C7 Coupes and Z06 Coupes
Installation: Bar attaches to factory mounting points in "B" pillars.


Browse for more products in the same category as this item:

Chevrolet > Corvette > C7 > Harness Mounting for C7