R-1032 Harness Mount Bar
R-1032 Harness Mount Bar for 991 (911 2011 - Current)


 
Alternative Views:


For Porsche 991 & 992
MSRP: $879.53


BK Part Number: R-1032
 

Description Installation Instructions
 
Harness Mount Bar pictured has a custom powder coat. All Mount Bars come with a wrinkle black powder coat.

The 991 harness mount bar has been tested and certified by an independent lab to handle the types of forces required by the National Highway Traffic Safety Admin. DOT and SAE J385 Rev.MAR 95, Motor Vehicle Seat Belt Anchorages-Performance Requirements. The 991 harness mount bar properly locates and supports racing shoulder harnesses relative to the driver. In the case of an accident, it helps protect the driver's shoulders and spine. The harness guides also prevent excessive shifting and fatigue of the driver during the high G loads of cornering and braking. Our bars are easy to install and remove, use only existing holes and mounting points, and will not damage the car in any way.

Strength requirements for harness mounts are considerably greater than those for harness guide bars since they must support the entire load applied to the belts. A mount really can't be relied on unless it has been tested to support the loads required by the National Highway Traffic Safety Administration.

The Brey-Krause Harness Mount supported the loads specified by the National Highway Traffic Safety Admin. DOT for upper torso restraints in all automobiles. Tensile tests performed by an independent lab.

Material: Type 304, stainless steel
Finish: Powdercoated in durable black wrinkle-finish
Weight: 16 lbs
Models: 991 & 992 (Targa models must use R-1033 down tubes)
Installation: Bar attaches to seat belt mounts & seat track hardware.
Miscellaneous: Bar is designed to allow enough seat travel for tall drivers. Includes provisions for Seat Back Brace.

Accessories:


Browse for more products in the same category as this item:

Porsche > 911 > 991 ('11-present) > Harness Mounting for 991